Gofab cns

I have a gofab table that 8s working. I want to convert to plasmac. Is this possible.

Can you tell us more about the computer it uses and the control hardware?

I will look. I know it has a mach 3 board. Gofab does all their own programming. It does use a wireless tablet. I will get the link for the last update and post it here. I can say there are many users that will be very interested in a solution.https:

gofabcnc.com/updates/
I'm sorry I don't know more about this. I appreciate any help.

Warrenh wrote: I will look. I know it has a mach 3 board. Gofab does all their own programming. It does use a wireless tablet. I will get the link for the last update and post it here. I can say there are many users that will be very interested in a solution.https:

gofabcnc.com/updates/
I'm sorry I don't know more about this. I appreciate any help.

If you mean something like this www.aliexpress.com/i/33040435894.html then it should be possible.

That is the board in the computer. Would this be a complicated process for someone with limited experience and is there a cost for plasmac

No PlasmaC is free for anyone to use.

My advice is to ditch the computer hardware you have now, Buy a Mesa 7i96 and wiring it to your existing stepper drives and sensors. Buy a small form PC and a new monitor and start from scratch.

You will end up with a far superior system for minimal outlay.

Warrenh wrote: That is the board in the computer. Would this be a complicated process for someone with limited experience and is there a cost for plasmac

If you are capable of drawing up a wiring diagram of the existing setup then you would be able to do it.