Error on startup of PlasmaC, does the torch need power?

CNCFred
Topic Author
Offline
Elite Member

6 years 7 months ago #160326 by CNCFred

Error on startup of PlasmaC, does the torch need power? was created by CNCFred

Dear all,
I configured plasmac first part and wanted to continue, the plasma has no power and I get following error on linuxcnc plasmac startup.

Attachment not found

attached is as well the log file...

THANK YOU!

Please Log in to join the conversation.

tommylight
Away
Administrator

6 years 7 months ago #160328 by tommylight

Replied by tommylight on topic Error on startup of PlasmaC, does the torch need power?

twopass: Error in file ./plasmathc.hal:
setting parameter 'hm2_7i96.0.encoder.00.filter' to '1'
parameter or pin 'hm2_7i96.0.encoder.00.filter' not found

Attach the hal and ini files.

Please Log in to join the conversation.

PCW
Offline
Platinum Member

6 years 7 months ago #160331 by PCW

Replied by PCW on topic Error on startup of PlasmaC, does the torch need power?

Code:

parameter or pin 'hm2_7i96.0.encoder.00.filter' not found

hm2_eth: discovered 7I76E-16

Looks like you are using a 7I96 HAL file for a 7I76E

Please Log in to join the conversation.

CNCFred
Topic Author
Offline
Elite Member

6 years 7 months ago #160430 by CNCFred

Replied by CNCFred on topic Error on startup of PlasmaC, does the torch need power?

Thank you,
didn't pay attention....and see it is 796i only for the filter line....:whistle:
this is from the PlasmacUserguide....

Attachment not found

Please Log in to join the conversation.

phillc54
Offline
Platinum Member

6 years 7 months ago #160490 by phillc54

Replied by phillc54 on topic Error on startup of PlasmaC, does the torch need power?

CNCFred wrote: Thank you,
didn't pay attention....and see it is 796i only for the filter line....:whistle:
this is from the PlasmacUserguide....

Attachment not found

I will have to sack the proofreader :blush:

I'll fix that...

Please Log in to join the conversation.

Time to create page: 0.086 seconds