error or bug report on plasmac

hello,

i see something that I think is not ok in Plasmac. When i manualy jog, for example the X axis, I push the + button, and if I move the mouse up to Y selector tab with the mouse buton pushed, the x jog remain active to + moving and the y select for this moment I cant stop the X moving. For stop the moving, I need to go on the x tab and repush. In all this time the machine is moving to X+. With low speed is no problem, but at higher speed is

If is not clear what I explain, I will make a movie.

Axis or Gmoccapy ?

tommylight wrote: Axis or Gmoccapy ?

Axis

Just tested the 1350 build, it does not do that.
What build are you using? It is on the top of Linuxcnc screen.

I use axis 2.9.0-pre0-1019-g2e0f88e

I vaguely remember a bug report about jogging.

Is this your problem:
github.com/LinuxCNC/linuxcnc/issues/691