Hypersensing questions

rodw wrote:

bevins wrote:
I ordered the DR-15-24 same except not thin line. Still class II isolation and power supply.

Interesting. Aside from availability, I wanted to know what you got for the extra $. I had a look at the specs. the DR-15-24 has less output derating once the ambient temp goes above 50 deg C. That was about all I cold see.


Plasmac supports both ohmic sensing and float switch input at the same time so I would do both right at the beginning.

Well, at first I couldn't find the HDR, so I got the DR. ButI ordered the HDR after and got it today so. I don't know.... I got my 5 watt resistors today also.

Also got this baby connected and ready to go......
Not sure what I should turn on or test first....lol

Finally! The moment we've all been waiting for is getting closer! Its been a long time coming!

AH, have to wire the ohmic power supply and resitors and THCAD

bevins wrote: Not sure what I should turn on or test first....lol

Do the included wrench, i am still the only one who did not cut that ... yet !

tommylight wrote:

bevins wrote: Not sure what I should turn on or test first....lol

Do the included wrench, i am still the only one who did not cut that ... yet !

Don't you use ER32 collets Tom?

phillc54 wrote:

tommylight wrote:

bevins wrote: Not sure what I should turn on or test first....lol

Do the included wrench, i am still the only one who did not cut that ... yet !

Don't you use ER32 collets Tom?

Nope, again "yet", but i do have 2 of ER20 collet spindles collecting dust somewhere in the shop, got the used or most probably fried as i did test one with a VFD and the poor VFD kept complaining about over current.
Of more urgency would be to do some 9mm ones for changing the electrodes on the torches.

tommylight wrote:

bevins wrote: Not sure what I should turn on or test first....lol

Do the included wrench, i am still the only one who did not cut that ... yet !

Neither have I. I think Phill bought his Collet chuck after I adopted Plasmac in the early days....
And I already had a safety spanner for my ER32....

rodw wrote: And I already had a safety spanner for my ER32....

It amuses me that on lathes.co.uk he describes any lathe tailstock without a lever as "operated by a self hiding spanner"

ok, have to compile the ohmic3 comp now.

Everything is plugged and powered up.

What wrench are you talking about?