Trouble with float switch

# Keep your plasmac i/o connections here to prevent them from
# being overwritten by updates or pncconf/stepconf changes

# Other customisations may be placed here as well
# This file is built by the configurator in your configuration directory

#***** DEBOUNCE FOR THE FLOAT SWITCH *****
# the lower the delay here the better
# each 1 is a 0.001mm (0.00004") increase in probed height result
loadrt debounce cfg=3
setp debounce.0.delay 5
addf debounce.0 servo-thread

#***** arc voltage lowpass cutoff frequency *****
#***** change to the cutoff frequency you require *****
setp plasmac.lowpass-frequency 0

#***** the joint associated with the Z axis *****
net plasmac:axis-position joint.3.pos-fb => plasmac.axis-z-position

#net plasmac:arc-voltage-in ***YOUR_PLASMA_ARC_VOLTAGE*** => plasmac.arc-voltage-in
#net plasmac:float-switch ***YOUR_FLOAT_SWITCH*** => debounce.0.0.in
#net plasmac:breakaway ***YOUR_BREAKAWAY_SWITCH*** => debounce.0.1.in
#net plasmac:ohmic-probe ***YOUR_OHMIC_PROBE*** => debounce.0.2.in
#net plasmac:torch-on => ***YOUR_TORCH_ON***
#net plasmac:ohmic-enable plasmac.ohmic-enable => ***YOUR_OHMIC_PROBE_ENABLING_CIRCUIT***

# a 1 here allows multiple tools to be used
# gcode M3 S1 needs to be changed to:
# M3 $0 S1 for the plasma torch'
# M3 $1 S1 for the scribe'
setp plasmac.multi-tool 0
#net plasmac:scribe-arm plasmac.scribe-arm => ***YOUR_SCRIBE_ARMING_OUTPUT***
#net plasmac:scribe-on plasmac.scribe-on => ***YOUR_SCRIBE_ON_OUTPUT***