Display problem plasmac V.0.124

phillc54 wrote: Do you have multitool enabled in your connections Hal file?

Yes I believe so - setp plasmac.multi-tool 1 Would this be why $2 does not turn the torch on?

It needs to be 1 to allow $2 to work so you have it set correctly.

EDIT: Have set the Spotting Threshold and Delay in the Congig Panel?

If your image doesn't quite fit you could revert to LinuxCNC 2.8, it doesn't have the active g-codes on the main screen, they are in the MDI tab.

I forgot to mention that you cannot use MDI while paused, the interpreter needs to be in idle mode.

tommylight wrote:

phillc54 wrote: Thanks Tom, where did that pic come from?

Forum, right click on image, view image info on the context menu.

A bit different in Chrome but I get the idea. Neat trick Tom.