- Posts: 22010
- Thank you received: 3
Z axis probe height init
- tommylight
-
- Offline
- Administrator
-
6 years 5 months ago #169204
by tommylight
Replied by tommylight on topic Z axis probe height init
This is one of those rare moments in life when saying "i told you so" feels so good !phillc54 wrote: Well not many folk must use that feature, I broke it last August... :blush:
Please Log in to join the conversation.
6 years 5 months ago #169208
by phillc54
Replied by phillc54 on topic Z axis probe height init
Islander261 wanted that feature and I guess when you have 3000 pierces a sheet any probes you don't have to do could save a lot of time.tommylight wrote:
This is one of those rare moments in life when saying "i told you so" feels so good !phillc54 wrote: Well not many folk must use that feature, I broke it last August... :blush:
Please Log in to join the conversation.
- tommylight
-
- Offline
- Administrator
-
6 years 5 months ago #169209
by tommylight
The most i have seen so far is roughly 250 pierces on a 3x2m sheet.
Replied by tommylight on topic Z axis probe height init
Yup, i do remember that, so that will save him a lot of time.phillc54 wrote:
Islander261 wanted that feature and I guess when you have 3000 pierces a sheet any probes you don't have to do could save a lot of time.tommylight wrote:
This is one of those rare moments in life when saying "i told you so" feels so good !phillc54 wrote: Well not many folk must use that feature, I broke it last August... :blush:
The most i have seen so far is roughly 250 pierces on a 3x2m sheet.
Please Log in to join the conversation.
Time to create page: 0.035 seconds