setting up thcad

I will try to use that file tomorrow if i get a chance to get by my shop where the machine is and will try and screen shot an problems if i have them. Thanks again

So I just tried the new file, still getting wild fluctuating voltage readings from 120-160 When the machine is sitting idle. I’ve tried going over every connection and it even does it with the thcad unplugged from the 7i96 board. With the thcad unhooked it does vary more scrolling from 20v to 8-900

Update**
When cutting with settings of 115v on the thc the voltage read from 240-270 constantly varying like it does at idle.

Compress the configuration folder and attach it here, screenshots of run and config panel, pictures of how the THCAD is wired and to what it is connected, etc.

I had trouble initially learning to edit files in Linux. I recommend using gedit, you'll be able to open, read, edit, and save the files with the original file extension.

dvn4life1972 wrote: I had trouble initially learning to edit files in Linux. I recommend using gedit, you'll be able to open, read, edit, and save the files with the original file extension.

If you install geany you will never use gedit again
sudo apt-get install geany

rodw wrote:

dvn4life1972 wrote: I had trouble initially learning to edit files in Linux. I recommend using gedit, you'll be able to open, read, edit, and save the files with the original file extension.

If you install geany you will never use gedit again
sudo apt-get install geany

Ahh, editor wars...
I often have atom, geany, leafpad an nano open on the dektop at the same time.

No editor wars here, I know when I'm massively out-gunned!

Sorry for the delay i have been away from the shop, attached is my configuration file as well as a copy of an image i found on another forum that i used to wire my thcad10. Machine still shows wild voltages on the thc even if i completely disconnect the thcad.

Appears the image did not come through on the previous post, here it is.