Error Recovery

No, it still will only go in reverse as far as the last cut.

phillc54 wrote: No, it still will only go in reverse as far as the last cut.

Oh right that makes sense. It's still early here.

snowgoer540 wrote: The pause stuff no longer works the way I used to remember, I could sometimes execute the next line (which was to turn the velocity back to 100%), but I could never get it to execute line to start the rapid motion to go to the next hole. This would be when it would arc-out at the end of the cut. I was unable to get it to keep going through the code to go to the next feature and start cutting again.

Fixed...

phillc54 wrote:

snowgoer540 wrote: The pause stuff no longer works the way I used to remember, I could sometimes execute the next line (which was to turn the velocity back to 100%), but I could never get it to execute line to start the rapid motion to go to the next hole. This would be when it would arc-out at the end of the cut. I was unable to get it to keep going through the code to go to the next feature and start cutting again.

Fixed...

Good deal! I'm excited to get back to testing this, and see what else I can break :evil:

snowgoer540 wrote: Good deal! I'm excited to get back to testing this, and see what else I can break :evil:

HaHa, please don't try too hard.

One small note, 0.142 is listed twice in the upgrade sticky, and in the versions.html.

snowgoer540 wrote: One small note, 0.142 is listed twice in the upgrade sticky, and in the versions.html.

Oops :blush: At least I got it right in the other files, I'll fix it tomorrow.

phillc54 wrote:

snowgoer540 wrote: One small note, 0.142 is listed twice in the upgrade sticky, and in the versions.html.

Oops :blush: At least I got it right in the other files, I'll fix it tomorrow.

Sorry, I feel like a bit of an a5$ pointing it out... my OCD got the better of me this morning.

snowgoer540 wrote: Sorry, I feel like a bit of an a5$ pointing it out...

You should not.
You are like a guided missile for finding bugs!

rodw wrote: You can contact me here and we can discuss off forum. www.vmn.com.au/contact-us

This fell off my radar, but I did send you a message there in the "contact us" section. Maybe it went to your spam folder :laugh: