Feature Request

snowgoer540 wrote: Oh, so in that particular case, the offset does not get cleared at Plasmac Max Height?

Technically it is never cleared at PLASMAC_MAX_HEIGHT. It is cleared at START_HEIGHT. If PLASMAC_MAX_HEIGHT was equal to START_HEIGHT then it would appear to cleared at PLASMAC_MAX_HEIGHT.

Where I said:
After reaching PLASMAC_MAX_HEIGHT any remaining OFFSET is cleared.
I actually meant:
After reaching PLASMAC_MAX_HEIGHT any remaining OFFSET is reduced each servo cycle at a rate that moves the Z axis at the Setup Speed value in the Config Panel. This moves the Z axis to the START_HEIGHT. When START_HEIGHT is attained the OFFSET will have been reduced to zero and then offsets will be disable..

phillc54 wrote:

snowgoer540 wrote: Oh, so in that particular case, the offset does not get cleared at Plasmac Max Height?

Technically it is never cleared at PLASMAC_MAX_HEIGHT. It is cleared at START_HEIGHT. If PLASMAC_MAX_HEIGHT was equal to START_HEIGHT then it would appear to cleared at PLASMAC_MAX_HEIGHT.

Where I said:
After reaching PLASMAC_MAX_HEIGHT any remaining OFFSET is cleared.
I actually meant:
After reaching PLASMAC_MAX_HEIGHT any remaining OFFSET is reduced each servo cycle at a rate that moves the Z axis at the Setup Speed value in the Config Panel. This moves the Z axis to the START_HEIGHT. When START_HEIGHT is attained the OFFSET will have been reduced to zero and then offsets will be disable..

Ok, believe it or not, I’m following along, that actually makes sense. I bet that python code is significantly more difficult than rezooming the preview :laugh:

snowgoer540 wrote: Ok, believe it or not, I’m following along, that actually makes sense. I bet that python code is significantly more difficult than rezooming the preview

That is in the component so it is C and it is not that comlplex, just count towards zero at a rate of nnn then stop.

phillc54 wrote: That is in the component so it is C

Oh right C not Python... I have much to learn lol