Plasmac has a dedicated forum at plasmaspider

Guys, I know this is The forum for Plasmac support, but the admins over at plasma spider have created a dedicated forum for Plasmac

www.plasmaspider.com/viewforum.php?f=203

Previously Linuxcnc was bundled in with CommandCNC which felt a bit awkward :dry:

So if any of you guys are on the spider, there is an existing post there so feel free to chip in and give your feedback of your Plasmac experience.

Went there, got disappointed as usual, came back here where it is warm and cosy !
Nothing but f@#$ adds there, and nothing can be downloaded without plopping 20 or more $. Basically the same thing you get with the hardware from the same owner, and my replies to their THC's were promptly deleted several years back.

tommylight wrote: Nothing but f@#$ adds there, and nothing can be downloaded without plopping 20 or more $.

I have always been curious how this forum’s server, etc. gets paid for?

snowgoer540 wrote:

tommylight wrote: Nothing but f@#$ adds there, and nothing can be downloaded without plopping 20 or more $.

I have always been curious how this forum’s server, etc. gets paid for?

Sheetcam commissions :laugh: