Torch doesn’t move when voltage changes

6 years 1 month ago #183677 by Aldenflorio

Replied by Aldenflorio on topic Torch doesn’t move when voltage changes

Thank you. I’ll mess with it tomorrow and tell you how it goes.

Please Log in to join the conversation.

6 years 1 month ago #183693 by tommylight

Replied by tommylight on topic Torch doesn’t move when voltage changes

Set Proma as low as possible for hyst and delay.
In PlasmaC lower the pid value form 10 to 6 or 7, not the speed.

Please Log in to join the conversation.

6 years 1 month ago #183712 by Aldenflorio

Replied by Aldenflorio on topic Torch doesn’t move when voltage changes

I don’t have pid. I configured plasmac on mode two. Should I have used a different mode?

Again I have the proma 150 compact thc, not the proma sd

Please Log in to join the conversation.

6 years 1 month ago #183716 by tommylight

Replied by tommylight on topic Torch doesn’t move when voltage changes

Sorry, my bad.
THC speed, should be 6 or 7 for normal use with Proma.

Please Log in to join the conversation.

6 years 1 month ago #183718 by Aldenflorio

Replied by Aldenflorio on topic Torch doesn’t move when voltage changes

6 or 7 percent of the max velocity of the z axis?

Please Log in to join the conversation.

6 years 1 month ago #183728 by tommylight

Replied by tommylight on topic Torch doesn’t move when voltage changes

THC speed on the PlasmaC config tab.
Did you set the Proma as mentioned twice above ?

Please Log in to join the conversation.

6 years 1 month ago #183732 by Aldenflorio

Replied by Aldenflorio on topic Torch doesn’t move when voltage changes

I followed your guide from the link we both had. Except for the second step “ voltage difference at 2” bc I don’t have voltage difference anywhere

Please Log in to join the conversation.

6 years 1 month ago #183739 by tommylight

Replied by tommylight on topic Torch doesn’t move when voltage changes

Aldenflorio wrote: Except for the second step “ voltage difference at 2” bc I don’t have voltage difference anywhere

That is the "hys" on the Proma.

Please Log in to join the conversation.

6 years 1 month ago #183740 by Aldenflorio

Replied by Aldenflorio on topic Torch doesn’t move when voltage changes

Ok. So then it’s followed

Please Log in to join the conversation.

Time to create page: 0.067 seconds