Losing Arc On Holes

Hi All,

Does anyone have trouble losing an arc when cutting holes?

I’ve got to a point now where no matter what lead in or lead out I use, I can’t cut any more than 2 holes in a row without losing a valid arc.

Any help is appreciated

(Ps. I thought I saw a thread on something similar to this once but can’t find it)

Yes it's been happening a lot, and yes it is already fixed but the buildbot is for some resaon not updating the builds, although i am not sure Phill pushed the fix yet.
I did test it on two machines and it works properly set at 0.3 sec delay.

Yeah I definitely need to update then, havnt updated for a few months.

Also, anyone who comes across this thread for future notice, I set the lead-in to perpendicular instead of arc and have had much better results, only about 8% of holes give an error now.

tommylight wrote: Yes it's been happening a lot, and yes it is already fixed but the buildbot is for some resaon not updating the builds, although i am not sure Phill pushed the fix yet.
I did test it on two machines and it works properly set at 0.3 sec delay.

I will push that some time tomorrow.