Hypertherm 1100 Terminal

Hi All,

This post is not plasmaC related but may be useful for some people. I will delete afterwards if not allowed, however I am out of options and this is the best forum online.

I want to know if anyone knows the size of the terminal pins on a hypertherm 1100 to connect my CandCNC connection kit. I bought these cable headers and i think the pitch is right but the terminal pins are much too thick for it. Does anyone have any advice? Im about on my knees here.

Regards

Here is a picture of the terminals, they are 1.2mm thick and about 11.5mm high

Do you have any old PC power supply ? Try the floppy power connector, it is 4 pin .