Pro_El wrote: Hello all, i am starting to work on my new project, that is new plasma machine with 7i77, THCAD 300, LCNC 2.9 and QTPlasmac. I have made some research but i have some question.
1. Can i use ClassicLadder on QtPlasmaC, normally to configure ladder with my base-machine configuration
I can't see why not.
2. I found one PP for PlasmaC revision F and one PP for PlasmaC inside new version of SheetCam. They don't look the same. Which one to use?
I am not sure which version is in SheetCam, so use the one from
here
3. I have plasma cutter TehnoSol that can receive signal from 0 to 10V analog for output Amps adjust. I now this is solved for HyperTherm via serial communication but i want to now is this possible to control with QtPlasmaC.
I don't know enough about the 7i77 but you can connect to either of the hal pins qtplasmac.cut_amps-s (S32) or qtplasmac.cut_amps-f (Float) to get the required cut amps.
