THC not controlling

wade956
Topic Author
Offline
Junior Member

5 years 7 months ago #203135 by wade956

THC not controlling was created by wade956

Hi all, I have converted to QTPlasmac and since them it appears my THC is not moving. It does appear to call to move the z axis but it doesn't move. Any suggestions would be appreciated. Even with plasmac it was slow but it did move.

Please Log in to join the conversation.

snowgoer540
Offline
Platinum Member

5 years 7 months ago #203140 by snowgoer540

Replied by snowgoer540 on topic THC not controlling

I was doing a little testing myself today, and I see the same issue.

I am confident Phill will get it sorted, just hang tight

Please Log in to join the conversation.

phillc54
Offline
Platinum Member

5 years 7 months ago #203188 by phillc54

Replied by phillc54 on topic THC not controlling

wade956 wrote: Hi all, I have converted to QTPlasmac and since them it appears my THC is not moving. It does appear to call to move the z axis but it doesn't move. Any suggestions would be appreciated. Even with plasmac it was slow but it did move.

Thanks for reporting this, I forgot to give THC a feed rate. :blush:

The fix has been pushed. If you have a Buildbot install then you will need to wait until the Buildbot is finished.

buildbot.linuxcnc.org/buildbot/grid

Please Log in to join the conversation.

Time to create page: 0.082 seconds