THC velocity

More
5 years 7 months ago #203817 by wade956
THC velocity was created by wade956
Hi all, I’m running Qtplasma and I’m trying to increase the velocity my torch changes when the THC is active. I have increased my max velocity on my Z axis but it doesn’t appear to change the velocity when the THC is active.

Please Log in to join the conversation.

More
5 years 7 months ago #203821 by snowgoer540
Replied by snowgoer540 on topic THC velocity
Try changing the P value for the PID tuning. It defaults to 10. Try 20 or so. Smaller increments because it will oscillate if it goes too high.

Please Log in to join the conversation.

More
5 years 7 months ago #203823 by wade956
Replied by wade956 on topic THC velocity
I changed that to 40 and it didn’t seem to change.

Please Log in to join the conversation.

More
5 years 7 months ago #203826 by rodw
Replied by rodw on topic THC velocity
What mode are you using? If not using Linuxcnc to control the torch height, what THC are you using?

Please Log in to join the conversation.

More
5 years 7 months ago #203829 by wade956
Replied by wade956 on topic THC velocity
I'm using a Mesa THC -300 and mode 0

Please Log in to join the conversation.

Time to create page: 0.155 seconds
Powered by Kunena Forum