Run/Step Hold/Resume Buttons

This is my pendant.hal file that I use for a pendant. In the reconfigure section it shows how the original signals are unlinked and then netted again with or components. You could probably do something similar to net your button signals.



Edit:
I just noticed you have multiple posts on this, it makes it hard to follow...

phillc54 wrote: Edit:
I just noticed you have multiple posts on this, it makes it hard to follow...

+1

tommylight wrote:

phillc54 wrote: Edit:
I just noticed you have multiple posts on this, it makes it hard to follow...

+1

You’re actually at +2 on this Tommy; it’s been mentioned before...

forum.linuxcnc.org/plasma-laser/42067-th...ions?start=10#204296

Add another +1 from me though too.

snowgoer540 wrote:

tommylight wrote:

phillc54 wrote: Edit:
I just noticed you have multiple posts on this, it makes it hard to follow...

+1

You’re actually at +2 on this Tommy; it’s been mentioned before...

forum.linuxcnc.org/plasma-laser/42067-th...ions?start=10#204296

Add another +1 from me though too.

Snowblower - You love to pile on, you are the least helpful member of this forum imo. I started a fresh post to ask for help on the exact task I was struggling with. My original question (which was tagged onto the end of a ten year old thread) was quickly stagnant... so I started a fresh thread. The new thread got me the answers I was looking for within hours... so what's your problem? If you can help me with the task, great, if not then just don't chime in at all.

bevins wrote:

txtrone wrote:

bevins wrote: Yes but there is already pause resume being used by plasmac in the gui. You have to make it coexist.

I know, that is what I am trying to figure out how to do. Do you know how to accomplish this?

I dont have the plasmac. I quickly up[graded top QTplasmaC as it is much easier for me to see what is going on. Everything is in the hal and ini files.
Plasmac I never understood the structure.

I dont know how you would do that in plasmac but in QT I have an idea how I would accomplish it.

Thanks Bevins. I may look into upgrading to QT.