QTPlasmc GUI questions

I was wondering if it was possible to change / expose (via the gui >> Parameters >> GUI Settings frame) the options to change the jog speed % (hare / tortoise) [same as gmoccapy] / or via hal/ini file?

I was also wondering if it was possible to change or expose the number of decimal places for the DRO's

None of these are show stoppers / issues of any significance, I was mearly just wondering if the settings could be changes as I can see + adjust them in gmoccapy thats all

I was wondering if it was possible to lower the CUT AMPS within the material settings to 10A minimum (presently 15A), but the hypertherm 45xp uses 10A for marking,

thanks

We can take a look at all of those...

DRO uses properties for the metric/imperial/angular templates
So you can change them with the stylesheet.

Maybe that's not convenient enough - you can always set properties directly in python code too.

There is a new hal pin for slow jogging, called qtplasmac.ext_jog_slow.

Cut Amps minimum is now 10.

I am not sure of the required styleshhet properties for the DRO, maybe Chris will post them here then you could set up a custom style or a custom stylesheet.
linuxcnc.org/docs/devel/html/plasma/qtpl...mizing_qtplasmac_gui
 

thanks Gents
I'll have a play tonight

Then you will probably have to change cycle g20/g21 to get it to change.
I'll fix that bug soon.

Chris