PnCConf Wizard doesn't launch

More
5 years 2 months ago #217291 by phillc54
Replied by phillc54 on topic PnCConf Wizard doesn't launch
PlasmaC is still being supported, so bugs will be fixed, It is not having any new features added.

Please Log in to join the conversation.

More
5 years 2 months ago #217292 by CFE
Replied by CFE on topic PnCConf Wizard doesn't launch
Ahhh, thanks Phil, that's a relief, Let's hope the PnCConf Wiizard can be used soon, that would be great. Not just for us, but also other people who would like to get going with a 2.9 installation and a Mesa card.

Please Log in to join the conversation.

More
5 years 2 months ago #217293 by phillc54
Replied by phillc54 on topic PnCConf Wizard doesn't launch

Ahhh, thanks Phil, that's a relief, Let's hope the PnCConf Wiizard can be used soon, that would be great. Not just for us, but also other people who would like to get going with a 2.9 installation and a Mesa card.
Yes it was really disappointing that PnCconf had not been converted prior to the changeover and as you say frustrating. I hope it is not too long as well.

Please Log in to join the conversation.

More
5 years 2 months ago #217720 by phillc54
Replied by phillc54 on topic PnCConf Wizard doesn't launch
I have pushed the update to PnCconf, It seems to build configs Ok...

Please Log in to join the conversation.

More
5 years 2 months ago #217747 by crowloy
Replied by crowloy on topic PnCConf Wizard doesn't launch
I just pulled the latest update so I can use pncconf again. I get to a certain point in the program and then it fails. once it does, I have to cancel as forward/back give the same error. And of course I need pncconf, since I have a new 7i96 board I want to install in my CNC router box.

Please Log in to join the conversation.

More
5 years 2 months ago #217749 by phillc54
Replied by phillc54 on topic PnCConf Wizard doesn't launch
Are you using a VFD?
If so I think I know what is wrong, I should be able to fix it tomorrow.

Please Log in to join the conversation.

More
5 years 2 months ago #217750 by crowloy
Replied by crowloy on topic PnCConf Wizard doesn't launch
One last error. I'm also not using a vfd. Just trying to get past that screen

Please Log in to join the conversation.

More
5 years 2 months ago #217778 by phillc54
Replied by phillc54 on topic PnCConf Wizard doesn't launch
Is it possible for you to post a pic of each page with your selections up until you get the errors, I tried a few different mesa cards and options but I don't see the errors.

Never mind, I think I found it in the Advanced Options Page, I obviously didn't test that one. 
[img

Please Log in to join the conversation.

More
5 years 2 months ago #217788 by phillc54
Replied by phillc54 on topic PnCConf Wizard doesn't launch
I have pushed the fixes for those two errors, hopefully there aren't too many more... 
[img

Please Log in to join the conversation.

More
5 years 2 months ago #217821 by crowloy
Replied by crowloy on topic PnCConf Wizard doesn't launch
I was able to completely finish a run of pncconf and create a config. Thanks

Please Log in to join the conversation.

Time to create page: 0.100 seconds
Powered by Kunena Forum