I am looking at a backup of the config files. This is what I see. Dont know if it is complete or correct
Code:
#***** debounce for the float, ohmic and breakaway switches *****
# the lower the delay here the better
# each 1 is a 0.001mm (0.00004") increase in probed height result
loadrt debounce cfg=3
setp debounce.0.delay 5
addf debounce.0 servo-thread
setp hm2_7i76e.0.encoder.00.scale -1
setp hm2_7i76e.0.encoder.00.filter 1
setp hm2_7i76e.0.encoder.00.counter-mode 1
loadrt and2 count=1
addf and2.0 servo-thread
#***** arc voltage lowpass cutoff frequency *****
#***** change to the cutoff frequency you require *****
setp plasmac.lowpass-frequency 0
#***** the joint associated with the Z axis *****
net plasmac:axis-position joint.2.pos-fb => plasmac.axis-z-position
net plasmac:arc-voltage-in hm2_7i76e.0.encoder.00.velocity => plasmac.arc-voltage-in
net plasmac:arc-ok-in hm2_7i76e.0.7i76.0.0.input-06 => plasmac.arc-ok-in
net plasmac:float-switch hm2_7i76e.0.7i76.0.0.input-04-not => debounce.0.0.in
# net plasmac:breakaway hm2_7i76e.0.7i76.0.0.input-03-not => debounce.0.1.in
net plasmac:ohmic-probe hm2_7i76e.0.7i76.0.0.input-03-not => and2.0.in0
#net plasmac:ohmic-probe hm2_7i76e.0.7i76.0.0.input-03-not =>
net plasmac:ohmic-probe_out and2.0.out => debounce.0.2.in
net plasmac:ohmic-enable plasmac.ohmic-enable => and2.0.in1
net plasmac:torch-on => hm2_7i76e.0.7i76.0.0.output-01
# a 1 here allows multiple tools to be used
# gcode M3 S1 needs to be changed to:
# M3 $0 S1 for the plasma torch
# M3 $1 S1 for the scribe
# M3 $2 S1 for spotting
setp plasmac.multi-tool 0
# net plasmac:scribe-arm plasmac.scribe-arm => ***YOUR_SCRIBE_ARMING_OUTPUT***
# net plasmac:scribe-on plasmac.scribe-on => ***YOUR_SCRIBE_ON_OUTPUT***
