Greetings to all.
I am trying to install ohmic3.comp for the ohmic probe of my plasma machine, the steps that I have already done are the following:
1) Change the firmware with metaflash to enable the other encoder --- OK
2) Install the ohmic3.com component using the command sudo halcompile --install ohmic3.comp --ok
3) Copy the spaceship_ohmic.hal file to the configuration folder and load it from .ini using HALFILE = spaceship_ohmic.hal --- ok
4) I added in my custom.hal file: setp hm2_7i76e.0.encoder.01.scale -1 setp hm2_7i76e.0.encoder.01.counter-mode 1 ---- ok net ohmic-vel ohmicsense.velocity-in => hm2_7i76e.0.encoder.01.velocity
5) Check in hal show these variables and the encoder --- ok.
6) Connect the other THCAD-10 with its corresponding resistance to the other input of the 7i96 card.--ok
Just when I start QTplasmac Ohmic probe the z axis just has no movement it does nothing. Greetings to all.
