Float switch has disabled jogging

Hi, any time I try to jogg my machine it tells me 
float switch has been activated.
At first I was using BOB to control my machine I was having the same problem. Just recently I got my Mesa 7i92 board so I tot the problem will go but still it is there
Even disconnected the float switch but still.   

The float switch indicator is indeed active in both pictures.  When you disconnected the switch if you have the input inverted it will expect to have a closed circuit.  You may have to invert the input again, or just disconnect it in Hal.  

Which means I can't use the float switch?

aabtech wrote:

Which means I can't use the float switch?

No.
You CAN use the switch, just invert it in HAL.

Sorry I may have misunderstood your first post.  

To invert the input just add   -not  to the end of the input.  Or if you used pncconf you can go back in and just click “invert” next to the input.