Can you please release a version for cutting tubes?

It is hoped that on the current basis, a version that can cut pipes such as round pipes, square pipes, and elliptical pipes can be launched. Is there any development plan for this in the future?

Round pipes are easy, eliptical can be managed quite ok, sqare ..... not easy.
For round ones i use a normal XYZ config where Y is usually the round one, make configs for every diameter separatelly, and use Inkscape for CAM.
It is a sheet curled to a round shape, after all.
Also easy for use.
Square would need some work for sure.

Square needs fast Z axis accelleration and leave the change in height to be managed by the THC. This implies there will be a maximum cut velocity that is constrained by Z accel and size of the square.
Tube does not need a THC because the height will not vary.