convert SheetCam tools to QTPlasmaC material list

I am setting up a new DIY controller with QTPlasmaC and I would like to convert the SheetCam tool to the material list.
Any help is great
Thanks Tom V.

You have two options:

1. Use the converter as described  here
2. Have no materials in QtPlasmaC and get the SheetCam postprocessor to send the material information with each job as described  here

Moved to PlasmaC section.
-
-
P.S.
Should this section be renamed to QtPlasmaC?

+ 1

tommylight wrote:

Should this section be renamed to QtPlasmaC?

I've thought about this in the past too. PlasmaC technically still exists, so I think there's a few options:
1. leave as is
2. rename to PlasmaC/QtPlamaC
3. leave as is and start a new section for QtPlasmaC

snowgoer540 wrote:

3. leave as is and start a new section for QtPlasmaC

That!

I still use PlasmaC, despite....

snowgoer540 wrote:

1. leave as is
2. rename to PlasmaC/QtPlamaC
3. leave as is and start a new section for QtPlasmaC

Either 2 or 3, I have no real preference...

phillc54 wrote:

snowgoer540 wrote:

1. leave as is
2. rename to PlasmaC/QtPlamaC
3. leave as is and start a new section for QtPlasmaC

Either 2 or 3, I have no real preference...

I dont either. I also dont have the authority to do either. So I will leave it up to Tommy to decide.

thanks very much I will give it a try in the morning.

I would also be happy with No.2.
It would also be nice to remove these posts to keep the topic clean.
P.S.
I am not sure i have the authority to change the topic tittle, tinfoil hat etc etc.