Gap cut

More
3 years 10 months ago #258615 by paulsao
Gap cut was created by paulsao
Greetings to all.
If anyone has experience or has gone through this, the question is why does this lag occur in the cut?

Please Log in to join the conversation.

More
3 years 10 months ago #258724 by tommylight
Replied by tommylight on topic Gap cut
-cutting to fast
-air pressure low
-current low for given thickness
-vorn nozzle
-
Should have posted a picture of the under side also, before cleaning.

Please Log in to join the conversation.

More
3 years 9 months ago #261048 by paulsao
Replied by paulsao on topic Gap cut
Greetings the photos of the cut in front and behind without cleaning. 

Attachment not found

 

Attachment not found

Please Log in to join the conversation.

Time to create page: 0.086 seconds
Powered by Kunena Forum