Error with T0 M6 (select plasma tool)

Yesterday I made a new installation of linuxcnc with qtplasmac, when I try to run a code generated with sheetcam the torch stays immobile and remains at that point without sending any type of error, simply no axis moves. Trying to solve the problem, I generated a code from conversational mode and this code does execute without problems. What I found is that if I remove the line in the header in the initialization section of the material, the code T0 M6 the code runs again without problems. I don't know if there is any change that I should make to solve this problem, greetings and thanks for the support...

Can you upload the gcode file you are having issue with?

Otherwise we are just guessing

Of course, I attach both codes, the problem I found is in the header, regards

Both work.ngc and no-work.ngc run fine on my Virtual Machine over here.

I tested both on both a metric machine, and an imperial one.

Can you post a backup of your config (made from the settings tab)?

Thanks a lot for your time, I notticed that I delete the section for tool-number in the hal file, restored this lines and there no problems any more...

Looks like you are working with a fairly old configuration.  Did you migrate from plasmac?

Of the three lines you posted above, you only need to comment out/delete this one:



The other two should stay.

You could post your config if you'd like us to double check it.

It's not too old, I did it with stepconf last week, right now i only have the ini and the hal file

I thought you said you were running qtplasmac?

That ini file says very differently.

opps you're rigth, these are the files...last one was the config to check the set up for motors and drivers...