Error installing QTPlasmaC latest

This is the latest version that has been showing for the last two days.

linuxcnc-uspace_2.10.0~pre0.1787.g93a0bc31f

I have reported the sleeping Buildbot to the devs list.

Seems like the new buildbot is building for buster now and its ahead  of the old one. You could grab the Debs from here and install with sudo dpkg -i
buildbot2.highlab.com/debian/dists/buste...uspace/binary-amd64/

You could also modify the instructions in the 2.9 getting Linuxcnc docs (Heading #9) to get buster 2.9 and master from buildbot2
using these sources
buildbot2.highlab.com/

Rod I looked at that and it seems to me to be the typical Linuxcnc mess that I do my best to avoid. That is why I am using the old system with the most stable results and a well know process.
I used to like it at the bleeding edge but I have done my time. I am getting way to slow for that.

I leave it to the younger more agile guys

The buildbot caught up and everythings seems fine now. Thanks Phil.

Great, thanks Marius.