Startup Segmentation fault $EMCDISPLAY -ini "$INIFILE" $EMCDISPLAYARGS ...

I can run axis gui on this machine.

Trying to configure a Plasma machine but I can't boot up

Running Debian 10

 

The file you attached is missing the "debug information" part.

Understood, do these files have the info?

   

Did you install the required dependencies?
Should probably change to Debian 12 BookWorm as there will probably be dependency issues and Python versions.
Sorry for the limited reply, but no more info there except the segmentation fault.

I ran the script in the qtplasmac guide. But no luck I guess.. I will go the Debian 12 route. Thanks

Try my installer. I need a few testers
forum.linuxcnc.org/9-installing-linuxcnc...or-linuxcnc-x86-only