Having problems with my THCAD-10

More
2 years 10 months ago #287144 by aabtech
Replied by aabtech on topic Having problems with my THCAD-10
 

Attachment not found


yes it is  counting at times it stop not stable.

Please Log in to join the conversation.

More
2 years 10 months ago #287165 by rodw
Replied by rodw on topic Having problems with my THCAD-10

Open the "halshow" and check if the encoder is counting correctly.
THis is the step I told you to do earlier but you didn't

Yes you did Rod, i just reminded him.
Nothing against you Tommy. I just get frustrated when people miss a step and wonder why things are not working....
You need to be very methodical with linuxcnc connections. Check each step at a time before moving to the next!
A few more minutes now saves hours later...

Please Log in to join the conversation.

More
2 years 10 months ago #287230 by aabtech
Replied by aabtech on topic Having problems with my THCAD-10
The video above shows the encoder is counting in Hal show but now is not counting.

Please Log in to join the conversation.

More
2 years 10 months ago #287232 by tommylight
Replied by tommylight on topic Having problems with my THCAD-10
Encoder velocity ?
THCAD when wired correctly counts all the time, yours is idle on last picture.

Please Log in to join the conversation.

More
2 years 10 months ago #287248 by aabtech
Replied by aabtech on topic Having problems with my THCAD-10
now it is working the problem was my encoder A pins it was not working so i have to change to encoder B pins.
the encoder velocity and the count is reading.
 

Attachment not found

Please Log in to join the conversation.

More
2 years 10 months ago #287252 by tommylight
Replied by tommylight on topic Having problems with my THCAD-10
Notice the voltage in the GUI, now it shows 0 as it should.
Try cutting something ....

Please Log in to join the conversation.

More
2 years 10 months ago #287259 by aabtech
Replied by aabtech on topic Having problems with my THCAD-10
now the THC is working correctly. thanks very much tommy.

Please Log in to join the conversation.

More
2 years 10 months ago #287260 by tommylight
Replied by tommylight on topic Having problems with my THCAD-10
:)

Please Log in to join the conversation.

More
2 years 10 months ago #287278 by aabtech
Replied by aabtech on topic Having problems with my THCAD-10
Hi, I have been cutting different materials from 1mm to 30mm which THC settings is good for me?

Please Log in to join the conversation.

More
2 years 10 months ago #287281 by tommylight
Replied by tommylight on topic Having problems with my THCAD-10
That you will have to find out yourself, there is no "one fits all" in plasma cutting.
Start with Hypertherm cut charts and test from there, take notes and make a list of what works best for you.

Please Log in to join the conversation.

Time to create page: 0.119 seconds
Powered by Kunena Forum