Tandem StepGen

aabtech
Topic Author
Offline
Premium Member

2 years 10 months ago #287647 by aabtech

Tandem StepGen was created by aabtech

recently i change my Y AXIS wiring. at first i use to wire Y AXIS Motor 1&2 step & dir together to the board but now i tandem my Y Axis but my Y Axis do not move if i open QtPlasmaC my Y Axis look gray.

Attachment not found

Please Log in to join the conversation.

phillc54
Offline
Platinum Member

2 years 10 months ago #287649 by phillc54

Replied by phillc54 on topic Tandem StepGen

It will be grayed out until the machine is homed.

Please Log in to join the conversation.

aabtech
Topic Author
Offline
Premium Member

2 years 10 months ago #287747 by aabtech

Replied by aabtech on topic Tandem StepGen

Thanks very much. After homing all it worked.

Please Log in to join the conversation.

Time to create page: 0.076 seconds