Thanks very much lads.
After the update the RFL worked flawlessly, absolutely fantastic.
I kept getting stoppages mid cut, after very short distances. This was the first time I've used my new DIY pendant during cutting, so I turned it off, but still got a stoppage. So I finally unplugged the 25 pin connector to the 7196 expansion port (that's my pendant gateway to the 7i96) and absolutely no problems. Qtplasmac was rock solid all the way through the cut, which was an artistic cut with quite a lot of pierces.
So at some point I'll have to put a "sniffer" in my pendant communication system and see if I can track down the origin of some unwanted signals that are being sent to hal.
Thanks again, hope you guys have a great New Year's Eve.
