G64 Pn Qn Value Problems when running from Line in Qtplasmac

Hi, 
So im running qtplasmac v2.9-236.302. Yesterday i discovered a problem when running from line.
In general the Fusion PP puts in The G64 Pn and Qn values which i adjusted because the machine will start to round corners otherwise.
Now if i want to run a Program from line it loads the rfl.ngc temporary cut file. But when the file loads my G64 values are gone and the machine will start to round corners again. Any Suggestion on where to find the G64 Settings/Initialisation values for rfl.ngc?
Hope you can help thanks in advance.

Have you tried setting your G64 Pn Qn in the [RS274NGC] section of your ini file?

RS274NGC_STARTUP_CODE =

Thanks for the quick answer this is probably exactly what i was looking for. I will try it as soon as i startup the cutter today.
Many thanks.

I just tried modifying The RS274 startup code unfortunately it did not change anything in the rfl.ngc its still just the G64 command without any Pn or Qn values.

Moved to PlasmaC section.
-
What does rfl.ngc do?

I see this issue as well, it is a bug. I will look at it later today.

rfl.ngc is the G-code created for a run from line job.
 

phillc54 wrote:

rfl.ngc is the G-code created for a run from line job.

 

So a temporary file, nice.
Where does it get created? Just in case i ever need it.

tommylight wrote:

phillc54 wrote:

rfl.ngc is the G-code created for a run from line job.

 
So a temporary file, nice.
Where does it get created? Just in case i ever need it.

/tmp/qtplasmac/rfl.ngc along with a few others.

I have found the problem and will merge the fix shortly.

The fix has been pushed to 2.9 and master so should be available when the buildbots build the packages.
 

Wow that was fast as always thanks. That really helps a lot at first i thought i overlooked something in the configs. Though it normally isn't necassary to run from a specific line it always is nice to have for cut recovery.
Many thanks