Qtplasmac setup

Hello I am new here building a plasma table. I can figure out what the heck I am missing. I have my machine setup and running through pncconf wizard but can figure out how to get Qtplasmac working. I have read the documentation over several times and can figure out what I need to do next. Thank you

I am typing this in the terminal “ source ~/linuxcnc-dev/scripts/rip-environment” but it keeps saying non-existent file or something like that

Cdub wrote:

I am typing this in the terminal “ source ~/linuxcnc-dev/scripts/rip-environment” but it keeps saying non-existent file or something like that

That is required only if you built a run in place installation. If you installed a package then you only need to enter linuxcnc in a terminal.

Then what do I do after I enter linuxcnc?

I’m trying to get to Qtplasmac

Wow I was looking right over it the whole time. Thank you for the help.