QTplasmac Configs do not open after converting to master debs on buildbot2

I adjusted the apt settings so Debian gets  the buildbot2 deb file for LinuxCNC V 2.10. 
The upgrade of linuxcnc was sucessful.
When I open a config from the consiole, a window appears that says 
Updated to V2.10-001.017, Due to Configuration a Restart is required
I open the config and I get the same error
I reboot and I get the same error
I though tthen to check the ini fil to make sure it is not read only. It was so I updated the permisssions to write to it.
But I still can't open any config,  

How do I resolve this?
 

Ooops, this is QTplasmac specific and that is jut opening a Sim already on my PC. But I do need to edit a live sim
 

Moved to "PlasmaC" section.
Thank you.