XHC-WHB04B-6 pendant hal configuration

Studying the XHC-WHB04B-6 component and configuration with Qtplasmac.

I have these hal connections in my Qtplasmac hal file:

net    plasmac:program-pause         plasmac.program-pause       =>     halui.program.pause
net    plasmac:program-resume       plasmac.program-resume     =>     halui.program.resume
net    plasmac:program-run              plasmac.program-run           =>      halui.program.runHowever,

I also wish to connect the following XHC wireless pendant pins to the above hal pins.

whb.halui.program.pause 
whb.halui.program.resume
whb.halui.program.run

So do I need 2 input OR components to do this, example:

plasmac.program-resume
               OR                                                                    gives out:                         halui.program.resume
whb.halui.program.resume

My question rabbit hole goes deeper.
Is it possible that say my plasmac.program-run pin is logic HIGH, but then from the pendant the whb.halui.program.pause pin goes HIGH also, creating a “command conflict”.

Confused about all this at the moment.

Use these:

linuxcnc.org/docs/devel/html/plasma/qtpl...l#plasma:ext-hal-pin

Ah yes, I forgot about those. It's been a while since I used my table or read the Qtplasmac manual.

Thanks very much.

Glad to help, happy cutting.