Downlook Camera X Y Offset

More
3 years 8 months ago #265182 by cmorley
Replied by cmorley on topic Downlook Camera X Y Offset
most of the cam_align 2.9 docs will work in 2.8 (-o options depend on how new 2.8 is)

linuxcnc.org/docs/2.9/html/gui/qtvcp-vcp...vcp:panels:cam-align

Please Log in to join the conversation.

More
3 years 8 months ago #265188 by my1987toyota
Replied by my1987toyota on topic Downlook Camera X Y Offset
That's good .  Unfortunately I am currently running 2.8.0 on the PnP. I know I should upgrade to 2.9 I am just not
their yet. LOL. Mostly because my experience with Debian has been an exercise in futility.

Please Log in to join the conversation.

More
3 years 8 months ago #265190 by my1987toyota
Replied by my1987toyota on topic Downlook Camera X Y Offset
Of course the link shows a view of a circuit board. LOL

Please Log in to join the conversation.

More
3 years 8 months ago #265197 by my1987toyota
Replied by my1987toyota on topic Downlook Camera X Y Offset
I think I just found your Youtube channel cmorley. looks like you have dealt with qtvcp quite a bit.

Please Log in to join the conversation.

More
3 years 8 months ago #265249 by cmorley
Replied by cmorley on topic Downlook Camera X Y Offset
Yes qtvcp was started and maintained in linuxcnc by me.

Please Log in to join the conversation.

More
3 years 8 months ago #265320 by andypugh
Replied by andypugh on topic Downlook Camera X Y Offset
Generally you would define the camera as a tool and put the XY offset in the tool table.
Then you can "touch-off" to zero and the other tools (without the XY offset) will be aligned.

Please Log in to join the conversation.

More
3 years 8 months ago #265452 by my1987toyota
Replied by my1987toyota on topic Downlook Camera X Y Offset
Thanks Andy I will check that out .

Please Log in to join the conversation.

More
3 years 8 months ago #265526 by my1987toyota
Replied by my1987toyota on topic Downlook Camera X Y Offset
cmorley Are their any recommended tutorials on youtube that go in depth on using QTVCP on Linuxcnc?

Please Log in to join the conversation.

More
3 years 8 months ago #265561 by cmorley
Replied by cmorley on topic Downlook Camera X Y Offset
There are no videos that I know of, just the linuxcnc docs.
PyQT5 videos would be helpful if you want to do python extensions of widgets/screens.

Please Log in to join the conversation.

More
3 years 7 months ago #265759 by cmorley
Replied by cmorley on topic Downlook Camera X Y Offset
Just noticed this:


It's not much for explaining but demos the process.
I didn't actually watch the whole thing though.
This is for building a screen, building panels is basically the same.

Please Log in to join the conversation.

Time to create page: 0.131 seconds
Powered by Kunena Forum