New PP category

More
7 years 11 months ago #119951 by persei8
New PP category was created by persei8
It seems like a lot, if not most people on this forum are actual machinists rather than hobby woodworkers. Just wondering if it would be worthwhile to have a new PP category for Vectric Aspire users, if there are any. :)

Please Log in to join the conversation.

More
7 years 11 months ago #121425 by biqut2
Replied by biqut2 on topic New PP category
I am a machinist by day and also do woodwork on my own time too. I use Vectric mainly for my CNC router.

Please Log in to join the conversation.

More
7 years 11 months ago #121454 by tommylight
Replied by tommylight on topic New PP category
You should use the full name for post processor as there is path pilot that is mentioned here very often and most use the same PP for it.

Please Log in to join the conversation.

Time to create page: 0.068 seconds
Powered by Kunena Forum