QtPyVCP Plasma GUI

I started working on my QtPyVCP Plasma GUI and got a good start on nesting part subroutines this morning.



JT

I added an offset for the even rows to get better nesting.



JT

Very nice, indeed !
Thank you.

I've added part creation to my QtPyVCP plasma GUI so I can create a part then nest them and cut them out all in a few seconds. I can also test the code without firing the torch.



JT

Very cool! I'm curious, does this integrate with plasmac? Or have you written your own THC and things?

I just use the thc component, I have no idea what plasmac is or does.

JT

BigJohnT wrote: I just use the thc component, I have no idea what plasmac is or does.

JT

This one. Phill is developing
forum.linuxcnc.org/plasma-laser/35449-another-plasma-component

Its gathering a bit of a following,,,

in this days everyone is going in different direction
noone puts it all together
Plasmac revers run,mesting woudt be good to have in qtvcp envirerment

pl7i92 wrote: in this days everyone is going in different direction
noone puts it all together
Plasmac revers run,mesting woudt be good to have in qtvcp envirerment

I don't use qtvcp, I use QtPyVCP and all the stuff we do in QtPyVCP is fully shareable without having to clone LinxuCNC.

Reverse run is a branch off of Master that is broken at the moment if I recall correctly.

JT

rodw wrote:

BigJohnT wrote: I just use the thc component, I have no idea what plasmac is or does.

JT

This one. Phill is developing
forum.linuxcnc.org/plasma-laser/35449-another-plasma-component

Its gathering a bit of a following,,,

I'm familiar with the thread but don't have time to read 96 pages of discussion while it is being developed. Time is short for me at the moment and I have to skip most of the posts.

JT