Skip VCP Chooser at startup possible?

Hello Forum.

I have the QtPyVCP installed like the development install howto. I want to skip the VCP Chooser and want to start an existing VCP "probe_basic" as example. In my .ini i only can supply DISPLAY=qtpyvcp.

I appreciate any hint.

Best,
Udo

Add the second line

Display =qtpyvcp
Vcp=probe_basic

Over at www.qtpyvcp.com you can see the ini options on this page .

Not sure if the ini entry names are case insensitive or not.

JT

Thanks a lot!

I´ll try it out. Actually my controller rack is in a build state. If it´s ready i can start LCNC with 7i76E connected.

Thanls again!

Thank you John and Leon.

VCP=probe_basic in the .ini file at the DISPLAY section works like a charme.

Best,
Udo