Installation error

I adapted my ini-file to probe_basic and it started after commenting out some lines.
One problem still exists, the probe_basic window is pretty big, it doesn't fit on two
monitors with a resolution of 1280x1024 each.
Is there a possibility to put it in a window to scroll to the lower part
(which is unaccessible to me right now) or do I have to buy a new touch monitor?

IIRC, they are made to work on a full HD monitor, or 1920X1080 pixels.
You can turn those two monitors you have 90 degrees and set them in the monitor settings in Linux as rotated, then you would have 2048X1280, so plenty to fit in.

Tom's suggestion is a good one.
Hopefully Lcvette will make a smaller screen for those of us with small monitors ...
I'm hesitant to rebuild my control panel just so I can use probe basic, but its almost worth it.

Cheers,
Kurt

Excellent, I didn't even know I could turn both my screens, I got the whole window,
so I could play around and check it. It's funny on boot, when the messages scroll from right to left downside....
This screen is awesome!!!
At a first glance homing, jogging and loading a gcode file worked fine; Probing didn't work, I got a python error message.
Is it still under construction or did I mess up?

[Errno 2] Datei oder Verzeichnis nicht gefunden: u'/home/joe/linuxcnc/nc_files/probe_z_minus_wco.ngc'[Errno 2] Datei oder Verzeichnis nicht gefunden: u'/home/joe/linuxcnc/nc_files/probe_z_minus_wco.ngc'

Traceback (most recent call last):
File "/home/joe/qtpyvcp/qtpyvcp/widgets/button_widgets/subcall_button.py", line 67, in callSub
with open(subfile, 'r') as fh:
IOError: [Errno 2] Datei oder Verzeichnis nicht gefunden: u'/home/joe/linuxcnc/nc_files/probe_z_minus_wco.ngc'

This was my home setup for quite a while, 4 Eizo 24" monitors upside-down, and i think i posted a screenshot of Axis GUI here on the forum with that setup at 4800X1920 pixels.

@tommylight: nice setup.

I finally found the missing ngc files and copied them to the nc_file folder
and probing is fun!!

Nice to know your back in the game !
Thank you.