Probe Basic Screen Problem

First a Happy new Year to all

I wanted to use the Probe Basic Screen for my LinuxCNC Machine,
i am able to run the Screen with my Hal/InI Configuration but it is not Possible to enable the Machine.
The signal/pin for iocontrol.0.user-enable-out seems not to Work, when i use the machine with the simulated hardware it is functioning.

On which states depends this signal?

greetings Sven

Is it possible to get the machine out of e-stop ?
Posting your config files might help.

tommylight wrote: Is it possible to get the machine out of e-stop ?
Posting your config files might help.

When i use the gmoccapy screen i am able to reset and activate the machine.

My e-stop is created with a classicladder plc in both screensets.

But in the probe basic it seems not to work correctly.

I`ve added a tar.gz with my config.

Thanks