Probe basic manual tool change

Hello,

i am struggling with probe basic and the manual tool change.
If i select a tool and go then to touch of current tool, the sensor will be touched 2 times and the value is put in the tool table.

i have adapted all values as shown here  , but i have a problem.

Following situation: i want to mill an aluminum plate with 2 different tools. 
Load Tool 1 and make an "touch off current tool", than i set z to 0 at the top of the workpiece. Everything was god at this point, but now the spindle stops and i put the new tool in, and do the measurement, but now the tool did not touch the surface anymore.

I ve tried some ways to load and measure the tool, but i am getting the same problem each time.

If i try the measurement some times, my tool is getting longer and longer , starting at 44mm, up to 230mm at the end.

Best regards

Chris

have you give the right value for spindlelength?

Spindle length not, but i have not found anything about the length. I have only set in the spindle zero ( touching the clamping nut and the tool sensor )

Thats what i mean. Hmm ok.

Can you Post your file for M6 remap?

at the moment i have no remap in the ini file.
If i put the zero spindle positive ( in my case 119.85mm ), than the tool length will be too large , if i post the spindle zero negative , that the too length value is correct, but the measurement script did not spot automatically. I have tried a lot of configurations, maybe you have an idea ?     

I found another problem, if i try to change an tool mit T1 M6, nothing happen ( no Change tool window) and an script is hanging around ( i have to Stop the script with the stop button.

This sounds like you have no connection between the iocontrol.0.tool-change and iocontrol.0.tool-changed HAL pins.

These are the "handshake" that indicates that the tool change is finished.

icy wrote:

I found another problem, if i try to change an tool mit T1 M6, nothing happen ( no Change tool window) and an script is hanging around ( i have to Stop the script with the stop button.
 

or an error in your remapping.
If you use for example the gmocccapy M6 remap routines you need to edit some python files because of python version problems.
My edited version for a recent python 3 version can be found there: git.cnckloon.nl/PeterT/qtDragonNew/src/b...h/buttonBoard/python

Which version of the M600 do you use?
The configuration of version 1 and 2 is different.
The video was for version 1 .