Probe Basic rapids

Good afternoon,
I noticed while running a program that the rapids seems stuck at 60ipm, my machine is capable of running faster than that (and does when it uses a G1 as a rapid movement instead) but when a G0 is commanded it only runs at 60.

Ive attached a screen shot of what I am seeing in my INI and on the GUI

Can you move this to qtpyvcp section?
You might get a proper response there as the basic probe devs will get an email.

Chris

Can I do that as just a member? I dont see a place to move topics.

cmorley wrote:

Can you move this to qtpyvcp section?

Done.
Thank you.

can you post your whole ini file for us?

this isnt the latest, but its close enough, im not at my machine at the moment.

need to adjust your trajectory max velocity setting in the ini to match your desired programmed rapid velocity.

 

it is in inches per second, so setting of 1.0 inch/sec = 60 ipm should help figure out your desired max speed, but typically will match what you have higher up in the ini file from the pncconfig output think yours was 4.0 which is 240ipm

worked Perfectly, Thank you!