Probe Basic program run time stays 0:00:00

Timer doesn't start when i run gcode and always stays 0:00:00

Have added in .ini and
time.hal contains:
My config -  github.com/kriksis/Thor-cnc-7i76

Thnaks!

What version? If this is 2.9 master py3 branch time is not used anymore and you need to use the probe_basic post GUI Hal file instead, the time code is now in there

Its 2.8.2

you need to condense your post gui files into one file, i think only one can be called. likely why time.hal is not functioning correctly

Lcvette wrote:

you need to condense your post gui files into one file, i think only one can be called. likely why time.hal is not functioning correctly

You can call a single POSTGUI_HALFILE that contains references to several other HAL files:

It worked putting all in one postgui file.

Im using vistacnc pendant and in their .hal file there is this line -
and also time.hal uses pin halui.program.is-idle.
I get an error that pin is already linked.

How can i make them both happy?

With halui.program.is-idle being an out pin, simple modifactions of the pin assignment should work:
Delete from above:
net prog-running not.0.in <= halui.program.is-idle

replace by:
net program.is-idle not.0.in

You can connect a HAL out pin to multiple IN pins, however, it must be within one signal name. The signal name ist the first part after the net command.