Py3 - Probe Basic Config Conversion Doc Lcnc 2.9+

Better, better, but the error still pops up.
I'm pasting a screenshot with the report.

Attach here "coolant_cannon.hal"

I'm attaching the file.

Several things seem wrong in that file, but first, is there any reason for not using the PWM own scaling?
-
What is that file supposed to do?

I'm sorry, but I couldn't earlier.
I'll come across as a complete ignoramus, but I can't answer your questions.
As for PWM scaling, it seems to me that there should be such an option. I copied and added the "coolant_cannon.hal" file as instructed.
I'm completely frustrated, and I think I might give up. I can see that the conversion isn't straightforward; there are many variables that could lead to its failure (I think)...
Any ideas?

You can try omitting the coolant_cannon.hal and see if the main configuration starts.
What instructions are you following?

I tried to run it without this file.
The error no longer appears, but the program still doesn't start.
I'm sending a screenshot of the report.

Nothing showing there, go up a bit and take another screenshot.

Comment out the intro graphic line in the display section

Lcvette wrote:

Comment out the intro graphic line in the display section

I missed that, sorry.
Was looking for complicated stuff, as usuall.