Probe_basic Toolchanger

Hello,
yes - will post pictures next time i on the machine - the Spindle is a IBAG HF80 - with an Acomel VFD. Is a expensive one i have buy for an appel and egg - had to repair something like the Cooling-System and the VFD. But now is working all.
The mill is an EnderleCNC from 1999.

So here some pictures from my rebuild. Looks confusing - but you have seen it before There was a nightmare.
Now all is working - new tubes new cable no logic and rebuild housing and cooling-system - my yaskawa drives with the AC-Servos now working also fine. But cable laying around because not finish - yesterday i have setup the optiplex-oc with an extra grafic-card to use the probe-basic gui... but step after step to the goal.

Hello, sorry for the long waiting time. i´ve got too much projects ^^

ok now i have wired my 7i78 to the 7i76e and wired my nema23 stepper to the 7i78.

The Stepper / Changer works in MDI so when I Type G0 W360 the changer move´s 1 Postion. G0 W3600 is a 10 Position Move.

But the Motor is too small for the changer with full load of tools....

Hello can anyone tell how i get my stepper from the toolchanger in the velocity mod so i can control it by M64 and M65?

by the why is my stepper very slow when i configrue the stepper of w Axis?
when i configure my stepper of C Axis then the move normally

Ok got it work...

But the changer or probe basic is not saving my tools in the changer after quit linux cnc.

Can anyone tell me why?

Sorry i can not help with this, but i do keep reading ...

you may need to add some lines to your [RS274NGC] PARAMETER_FILE

either add lines for
5170 > 5171
5190 > 5209
5231

or copy over the sim.var or vmc.var from the sample configs to what ever you have the file names, but note this would override a bunch of you current numbered params

They current routines and the above only support a 12 pocket changer I have an open PR that supports changes up to 24 pockets, it requires adding params #3990 to #4024 instead of the above

Ok thank you i will check this.

At the moment i only have a 8 pocket Changer.

Wich params will it be override?

if you overwrite the file then anything listed in here as persistent
linuxcnc.org/docs/html/gcode/overview.ht...:numbered-parameters

mainly
G28, G30, G54-59.4 and more

can´t find any other params in sim.var from basic..... only the same params where my var.....