probe basic not working LinuxCNC V2.10.0

hi,  installing probe basic on Debian 12 LinuxCNC version 2.9 sim works fine, but when you upgrade to LinuxCNC V2.10.0 it not working. in Linuxcnc configuration selector probe basic lathe is working in sim. but probe basic not working and gives an error message. 

twopass: Error in file ./hallib/core_sim_5.hal:
Pin 'iocontrol.0.lube' does not exist

'iocontrol.0.lube' has recently been removed from master so maybe try removing it from ' ./hallib/core_sim_5.hal' and try again.

Now it is working thanks very much