Probe Basic Transition from Axis

Hello everyone, I'm a beginner in Probe Basic and I'm trying to transition from an Axis configuration to PB with ATC included, and I'm having some issues that I can't solve due to lack of experience. At the moment, I can open PB, if in my INI file the hal files (io.hal, spindle.hal, postgui.hal) are commented out. When I have not these file calls in the INI config, I can open PB, but it says I have to turn off EStop to be able to start the machine. I didn't have this problem with Axis. I've already reversed the signal call and it continues. Can anyone help me?Attached is my configuration. 

You need all of those files for pb, use the config conversion document in the sticky section.

forum.linuxcnc.org/qtpyvcp/48401-py3-pro...version-doc-lcnc-2-9

Yes, I have already followed this guide and successfully started and configured part of the Probe Basic. Now, I have this problem: is there a way to resolve it without losing all the progress I've made?

Did you press estop on the bottom left of the screen?

Yes, and it shows the same message.

When I migrated from Axis to Probe Basic I encountered something similar due to some e-stop signals in my custom.hal overlapping with the existing e-stop signals in Probe Basic.

I renamed my e-stop related signals to solve the problem.

Okay, do you suggest renaming in the main .hal file or in the halib?

Go through all the hal files and check which ones that refer to e-stop, also check out my thread in this forum section regarding the initialization problems I had which forced me to load my customs changes after the probe basic post gui file.

Thanks

What is the best recommendation to redo the entire configuration step by step. Any complements to the existing tutorial?