Tool Anzeige

Kann man auf der Seite Tool Vermessen , die Spalten A Offset bis w Offset  ausblenden ?
beim Werkzeug einmessen  muss immer den Schieber  betätigen das man die Zeile Remark sieht.
mfg
Hilton

yes, this is setup in the custom_config.yml file in the congifs folder. you will see the tool table column letters, simply change to the ones you wish deisplayed.

the below is a section from the custom_config.yml file:

data_plugins:
    tooltable:
        provider: qtpyvcp.plugins.tool_table:ToolTable
        kwargs:
        columns: TXYZDR <

---

these can be edited to display your desired columns.

Hi,

after my last reinstallation of LinuxCNC + Probe Basic i run into an equal problem that in my tooltable, where normaly has been shown 3 columns (number, Diameter, Info), there are now nearly 20 columns.

I tried to solve this with the "custom_config.yml" file, but nothing changed.
Is there an detailed info how exactly to use these yml-files with Probe Basic?
Do i have to do something more to activate the yml file?
Thanks a lot..

Best regards
Jens  

Dies the sim show correctly?

Yesterday, i did some further testing and at least i could solve the issue with my tootlable.

Thanks to all.